#How to use mic on bandicam full
#How to use mic on bandicam software

I'm only guessing, but I do usually use digicheck for capturing field recordings where I'm not having to use anything but the RME. The drive load using digicheck seems very low - since it only writes one file.

I notice at 40 secs that I'm not yet recording with digicheck and you hear pops and clicks for those first few secs then no more pops and clicks b/c digicheck is on.īapu, not that you would need this help (I'm guessing) but if you happen to be making a mobile recording with a laptop and want to capture the recording with digicheck, I think it can enable you to record more tracks at a higher sample-rate than Sonar could support with a given hardware limitation since Sonar writes them as distinct tracks as it goes. You can see me start talking - before I remember to start recording with digicheck. On the other hand, sometimes I get pops and clicks through the Microsoft Expression input. DigiCheck has never enabled some other audio program to mess up the DigiCheck recording. Now, DigiCheck + Sonar + Video Capture device all linking to your RME can get interesting, but in my experience DigiCheck always wins with the smooth recording. My voice - the mixture of my voice and Sonar (7+8) - The stereo pair as captured by the video capture. When I'm done, I can input as separate tracks - the stereo pair output from Sonar (5+6).

#How to use mic on bandicam full

Then, I set 5+6 for loopback and record 1 (my talking), 5+6 - full strength Sonar Output so you get real time fader movements and stuff the way they happen), and 7+8 (which has Sonar out mixed with my vocal as I heard it during the performance of the video recording). I also send the Sonar Mains to 5+6 (and also route to 7+8 so I can hear them using totalmix). For me, I always capture the audio on outputs 7+8 as the stereo pair for the recording. Alternatively, if you really can't capture audio with the video capture, you could sync up a mouse movement (like move the mouse to the lower right hand corner twice and tap the desk each time and sync the taps to the mouse movement. I can select Audio > Options and pick an input from the RME. I can also select and record RME inputs with CamStudio. I don't think they still support or sell this software.

#How to use mic on bandicam software

Well, I use MS Expression which is old software that you can choose the audio input for (and the rme inputs show up).